Moxa | Connect and Monitor J1939 Engines

Connect and Monitor J1939 Engines

SAE J1939 is a standardized protocol that operates in CAN (Controller Area Network) bus networks. It is widely used in industrial diesel engines designed for the heavy-duty vehicle industry, including on-highway trucks, off-highway equipment, agricultural equipment, construction equipment, and other vehicles. Ordinarily, engine control units (ECUs) are used to control these kinds of devices, and more and more applications are employing PLCs for process automation to monitor the status of J1939-supported devices connected to an ECU.

Moxa’s J1939 Gateway Makes Deployment Easier

During a project’s deployment, system integrators (SIs) must overcome several challenges, ranging from dealing with the complexity of different protocols and interfaces to spending too much time on pre-configuration and troubleshooting. With regard to these challenges, Moxa’s J1939 protocol converter is very easy to use and is equipped with a variety of maintenance functions to monitor the status of all connected CAN devices.

Download

MGate™ 5118 Series

1-port CAN-J1939 to Modbus/PROFINET/EtherNet/IP gateways

• Key-in-free J1939 command auto detection
• Built-in J1939 traffic monitoring/diagnostics/live-list tools
• Supports J1939 to Modbus RTU/ASCII/TCP, EtherNet/IP, PROFINET protocol conversion
• Ready for hazardous locations: C1D2, ATEX, IECEx
• MicroSD card for configuration backup/duplication, and event log
• 2 kV CANbus and Modbus serial port isolation
• -40 to 75°C wide operating temperature models available
• IEC 62443-4-2 compliant

Download the Datasheet